---

12.2 Coordinate Space

All coordinates are in mils (1/1000 of an inch). This is an arbitrary decision. Remember in there is no concept of physical lengths/dimensions in schematics and symbols (for schematic capture only).

• Origin is in lower left hand corner.
• The size of the coordinate space is unlimited, but it is recommended that all objects stay within (120.0, 90.0) (x, y inches).
• It is generally advisable to have positive x and y coordinates, however, negative coordinates work too, but not recommended.

The following figure shows how the coordinate space is setup:

X axis increases going to the right. Y axis increase going up. Coordinate system is landscape and corresponds to a sheet of paper turned on its side.