box (Lepton EDA Reference Manual 1.9.18)

12.4.4 box

Valid in: Schematic and Symbol files

type x y width height color width capstyle dashstyle dashlength dashspace filltype fillwidth angle1 pitch1 angle2 pitch2

Pos.	Field	Type/unit	Description
#	type	char	B
1	x	int/mils	Lower left hand X coordinate
2	y	int/mils	Lower left hand Y coordinate
3	width	int/mils	Width of the box (x direction)
4	height	int/mils	Height of the box (y direction)
5	color	int	Color index
6	width	int/mils	Width of lines
7	capstyle	int/mils	Line cap style
8	dashstyle	int	Type of dash style
9	dashlength	int/mils	Length of dash
10	dashspace	int/mils	Space inbetween dashes
11	filltype	int	Type of fill
12	fillwidth	int/mils	Width of the fill lines
13	angle1	int/degrees	First angle of fill
14	pitch1	int/mils	First pitch/spacing of fill
15	angle2	int/degrees	Second angle of fill
16	pitch2	int/mils	Second pitch/spacing of fill

The capstyle is an enumerated type:
- END NONE = 0
- END SQUARE = 1
- END ROUND = 2
The dashstyle is an enumerated type:
- TYPE SOLID = 0
- TYPE DOTTED = 1
- TYPE DASHED = 2
- TYPE CENTER = 3
- TYPE PHANTOM = 4
The dashlength parameter is not used for TYPE SOLID and TYPE DOTTED. This parameter should take on a value of -1 in these cases.
The dashspace parameter is not used for TYPE SOLID. This parameter should take on a value of -1 in these case.
The filltype parameter is an enumerated type:
- FILLING HOLLOW = 0
- FILLING FILL = 1
- FILLING MESH = 2
- FILLING HATCH = 3
- FILLING VOID = 4 unused
If the filltype is 0 (FILLING HOLLOW), then all the fill parameters should take on a value of -1.
The fill type FILLING FILL is a solid color fill.
The two pairs of pitch and spacing control the fill or hatch if the fill type is FILLING MESH.
Only the first pair of pitch and spacing are used if the fill type is FILLING HATCH.

Example:

B 33000 67300 2000 2000 3 60 0 2 75 50 0 -1 -1 -1 -1 -1

A box with the lower left hand corner at (33000, 67300) and a width and height of (2000, 2000), color index 3, line width of 60 mils, no cap, dashed line type, dash length of 75 mils, dash spacing of 50 mils, no fill, rest parameters unset.